EyeSIS - for inspecting surfaces

The Surface Inspection System EyeSIS is a compact system with an integrated software. The system is especially suitable for the surface inspection of aluminium, plastic, paper, glass as well as other materials. EyeSIS is employed where a high-quality appearance is required. The Ready-to-Use system detects scratches, cracks, dents, rust, inclusions as well as impurity on the test components without any problems.

For the inspection of the objects the system has to be parameterized only once by the means of the well-known EyeVision software. The system can be configured with a golden part in only a few steps. After the configuration, the checking is effected autonomously without a PC.

Henceforth all surface defects of the components are detected. According to the defined tolerance the system differentiates between tolerable irregularities, such as e.g. in case of tool marks, and non-tolerable defects.

With a sequence of multiple systems, the user has the possibility to check objects with different methods. Therefore the inspection reliability increases and the pseudo rejection due to the defects is reduced.

EyeSIS guarantees the user a fast and consistent error detection. The system detects even minor defects due to a high scanning speed and high resolution sensors. On the basis of these characteristics EyeSIS is especially qualified for the adoption in the quality assurance.

The EyeView protocol with EyeZIP gathers all informations about defect characteristics during the running production. So the user has the evaluation data as well as image data for up to 64 sensors, with only one click, at his command. In the case of a fault the user detects the error source at once. Thus the user has the possibility to improve the production process continuously and systematically. EyeZIP possesses optional software interfaces to SAP, ORACLE or to a SQL data base that allow to transfer the measuring results to the administration data base.